Bluesky Builder Gel 30g - WHITE

Product no.: BUILDER 01-30
29.90


Available delivery methods: post, Matkahuolto, Express package, Posti Home Package, Parcel Connect, Nouto Vilhonkadun liikkeestä
Bluesky builder gels require their own BASE coat!
We recommend BASE 01
 
 
Instructions:
Preparation is key..
 
1. Start by filing your nail into the desired shape using the 100/180 grit shaping file.
2. Gently push back the cuticles and if needed, cut away any excess dead skin.
3. Carefully buff the surface of the natural nail using Bluesky's 100/00 grit buffer file. File just enough to remove any shine from the nail, over filing will thin out the nail and can cause permanent damage.
4. Cleanse the nail using Bluesky's Cleanser Wipes.
5. Dehydrate the nail using Nail Prep.
  • Nail prep cleans, dehydrates and removes any excess oils and dirt from the surface of the nail.
  • Nail prep evaporates from the nail in a few seconds. If this doesn't happen, the nail is still too moist.
  • Repeat until the evaporation process is fast. Note that if the brush is too wet, the evaporation will take longer.

6. Apply Bluesky's Acid Free Primer onto the nail to increase adhesion.

  • Let the primer airdry for about 1 minute. The surface will be sticky but do not touch it!
  • If you touch the primer with hair, clothes skin or anything else, you should cleanse the nail and start over.
  • Acid free primer works like 2-sided tape that helps the gel adhere to the nail.
  • Mixing different brands is not recommended. Using another brands' prep products can have a negative effec on the nails longevity.
7. Add a thin coat of Base Coat 01 on all nails, we recommend doing the thumbs separetly to avoid product spilling. Remember to cap the ends.
8. Cure in LED for 60 seconds and 2minutes in UV. The polish will be sticky after curing but this is normal.
9. Place the nail form in the correct angle under the nail so that the nail form is in straight line with the nail. Make sure the form isn't pointing too up or down. The form should sit underneath the nail so that there is no gap between the form and natural nail.
10. Take your Bluesky builder gel of choice and spread a thin layer of it on the nail and nail form in the length that you want. Cure in LED for 60 sec and UV 2 min.
11. Do another layer to make the nail thicker. Cure in LED/60sec or UV/2min. Repeat if necessary.
12. Once youre happy with the thickness, repeat it on the other nails. Remember to do one nail at a time to prevent the gel from spilling!
13. Remove the nail forms and clean the nail with a Cleanser Wipe. FIle the nail into the desired sgape using Bluesky's shaping file. Finish up the nail and even the surface using Bluesky's buffer file.
14. Cleanse the nails again using a cleanser wipe to remove any dust or dirt from the nail.
15. To finish off, add a layer of Top Coat or a coloured gel polish and top coat. Cure each layer of polish in LED/60 sec or UV/2min.

 

INGREDIENTS:
Bis-hema Poly/1,4-Butanediol Adipate)/Ipdi Copolymer, Isobornyl Methacrylate, Ethyl Trimethylbenzoyl Phenylphosphinate, May contain: CI 15850, CI 77891, CI 77491, CI 77510, CI 77289, CI 77492, CI 77499, CI 77742

 

Additional product information


Customers who bought this product also bought


Browse these categories as well: Builder Gels, Builder gels